Grabli-voroshilki wheel GVV-6M

GVV-6M voroshilka rake

Tedding of slanted weight, reversing and doubling of rolls are intended for a sgrebaniye of herbs from prokos in a roll. A rake no more than 6 degrees, at humidity of herbs are recommended to use both on sredneurozhayny, and on high-yielding artificial and natural haymakings with an equal relief or a bias no more than 70%. Besides a rake can be applied to a straw sgrebaniye after cleaning of grain crops.

Features and advantages:

1. Big width of capture – to 6 m.
2. High-quality collecting slanted weight in a friable uniform roll.
3. Teeths of driving wheels are made of quality spring steel and have the special curved form that allows them to work for a bend and torsion in two planes at once.
4. Diameter of a wire of tooth of the driving wheel for choice – 6 mm or 7 mm.
5. Thanks to a special form of teeths, a rake, during the work, has continuous contact at the same time of several teeths with the soil providing high-quality capture of slanted weight and without hit of the earth.
6. The strengthened cart of a rake in comparison with similar to GVV-6, namely: it is strengthened dyshlo, beams of basic wheels are strengthened, fists of fastening of beams of driving wheels are strengthened, the design of the mechanism of rise (lowering) of beams of driving wheels is processed. These changes allowed to increase rigidity and reliability of all design of the cart.
7. The tires of basic wheels 165/70R13 installed on a stamped drive 5J*R13 from the car VAZ.
8. As a nave of basic wheels the back nave of the VAZ-2108/2110 car assembled with the bearing and an axis is applied that repeatedly increases reliability and durability of this knot.
9. The cast nave of the driving wheel, complete with the installed radial bearings provides reliability and durability of work of this knot.
10. The stamped disk of the driving wheel with additional stiffening ribs, the increased diameter of an arrangement of fixing openings to 133 mm and their quantity to 6 pieces, provides more uniform distribution of load of a disk during the work. In total with a cast nave high reliability and durability of this knot is provided.
11. Beams with the driving wheels installed on them have a possibility of copying of a relief of the field.
12. Existence of an additional average wheel in the main complete set of a rake. This driving wheel allows to stir slanted weight on the center of a rake, in the place of laying of a roll.
13. Lower operational expenses of a wheel and manual rake in comparison with rotor: low costs of service of the car, in view of lack of difficult and expensive elements (such as driveshafts, gear wheels, clowns, etc.); lower energy consumption – for an agregatirovaniye is required a tractor with a smaller engine capacity.

Technical characteristics